![]() Any parts not functioning properly should be replaced to avoid further problems. When cleaning products manufactured with rubber hinges (Roll Up Tread 1/2″, Mid-Profile Roll Grate 3/4″, and Vinyl Hinge Low Profile 3/8″), inspect the hinges and locking mechanism to ensure that all parts are securely attached and are functioning properly.If applicable, periodically clean carpet and scraping inserts with a hot water extraction machineto remove soil and restore pile.Clean aluminum surfaces with soap and hot water, then allow mat to dry.Never apply wax or other polishing products to the surface of the units this would create apotential hazard.If the units are above a drain, ensure that nothing is blocking the water flow to the drain.(Vacuuming is the most effective method for this cleaning.) Each time the rails are cleaned, make sure there is no debris underneath in the recess this will prevent product from warping due to an uneven substrate and prevent long-term problems. Debris between the rails should be removed during the cleaning process. ![]() During other seasons, once per month should be sufficient. During the winter season, remove product and clean rails once per week.Beveled Vinyl Edge allows for surface mat use.Ĭleaning and Maintenance Instructions Recessed Aluminum Floor Mats.Edge is not attached to the Roll up mat – Holds the mat in place.Beveled Aluminum Edge that can be permanently screwed into the floor.Available with or without under-mat tongues upon request.Edge is attached directly to the Roll up Mat.Can be cut on site to fit various filling needs.A recessed frame option when pit has already been formed.Vinyl Spacer Edge offers a flush and easy transition from floor to mat.Recommended that screeding the pit floor to level with the horizontal leg of the frame profile.1/2″ total depth, 7/16″ to 1″ bottom leg.Use L Frame when the pit has already been formed.Shipping time depends on the type of Metal Finish desired: Standard Mill takes 1-2 weeks, Anodized Finishes can take 3-4 weeks.Aluminum Floor Mat 3/8″ include SURFACE or RECESSED frame options.This low profile mat is designed to allow dirt and moisture to fall below the surface so that it does not get tracked into the building.Aluminum Hinge Low Profile Roll Up Floor Mat 3/8″ are composed using 49% pre-consumer Recycled Content.Can be designed for Indoor or Outdoor use.The inserts may require replacing after time, but the aluminum mat itself will sustain. Aluminum Hinge Low Profile Roll Up Floor Mat 3/8″ are dependable entrance mats that can perform for decades.Made from 6063-T52 aluminum spaced on 2″ centers.LEED: Possible LEED- NC credits MR credit 4(1-2 points) MR credit 5 (1-2 points) IEQ credit 5 (1 point).Depth: 3/8″, with recessed “L” frame 7/16″ (level base). Stable and solid mat system with added vinyl cushion supports on the bottom of each segment.Aluminum Hinge Low Profile Roll Up Floor Mat 3/8″ is a popular aluminum Entrance Mat because of roll up ease during maintenance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |